Dear Members,
Today I bought myself a little Sluicy GS 16 Highbanker ( its compact and lightweight to be transported on caravaning trips) came with legs, spraybar etc. It was also within my price range.
I bought it fully knowing that I would need to make a couple of mods, based on reading what other members have said about their GS bankers.
Before these mods a couple of questions where I'd appreciate help:
I want to place a small bit of punch plate or cable tray over the grizzly bars to help classify and to stop all the bigger stuff going from the hopper through to the sluice tray.
Q1 Anyone know where I can purchase punch plate or cable tray plate? Or is another method just as good?
The Sluicy comes with carpet under the expanded mesh and riffles. I want to swap out the first section (under the hooper outlet) for miners moss/spaghetti mat.
Q2 What is the best spaghetti mat...- mat with a thin solid rubber backing or no backing?
I have a small 3HP 4 stroke pump with 1 1/2 inch inlet/outlet to the impellor housing...
Q3 on the suction (inlet side) should I use a solid type pipe or will lay flat work on the suction head side (my thinking is that layflat may collapse on the suction head side of the pump).
Q4 Any other recommended mods??
Thanks in advance :
Today I bought myself a little Sluicy GS 16 Highbanker ( its compact and lightweight to be transported on caravaning trips) came with legs, spraybar etc. It was also within my price range.
I bought it fully knowing that I would need to make a couple of mods, based on reading what other members have said about their GS bankers.
Before these mods a couple of questions where I'd appreciate help:
I want to place a small bit of punch plate or cable tray over the grizzly bars to help classify and to stop all the bigger stuff going from the hopper through to the sluice tray.
Q1 Anyone know where I can purchase punch plate or cable tray plate? Or is another method just as good?
The Sluicy comes with carpet under the expanded mesh and riffles. I want to swap out the first section (under the hooper outlet) for miners moss/spaghetti mat.
Q2 What is the best spaghetti mat...- mat with a thin solid rubber backing or no backing?
I have a small 3HP 4 stroke pump with 1 1/2 inch inlet/outlet to the impellor housing...
Q3 on the suction (inlet side) should I use a solid type pipe or will lay flat work on the suction head side (my thinking is that layflat may collapse on the suction head side of the pump).
Q4 Any other recommended mods??
Thanks in advance :