Motor Wiring Help Needed

[xcvator]

Just went connect up the new motor for the slant cabber, but I'm afraid the wiring diagram just makes no sense to me.
There doesn't seem to be any + or - markings so I'm hoping that somebody can advise me where to put what (without being rude)

And what are the 2 small connector strips for ?

I would really like to run it in an anti clockwise direction so nuts don't come undone

 

[aussiefarmer]

One picture is for clockwise the other is for counter clockwise

 

[aussiefarmer]

The wires in pic 2 are matching clockwise, if photo is rotated 1/4 turn anti clock wise.

 

[Dihusky]

If you want anticlockwise Xcvator, change the two brass links as in the drawing. Looks as though the red wire U1 is +ve in and the black wire on the terminal between U2 and Z2 in -ve. What is it a 12v DC motor?

 

[aussiefarmer]

Yes correct flip the two brass plates to change direction now I look properly

 

[xcvator]

If you want anticlockwise Xcvator, change the two brass links as in the drawing. Looks as though the red wire U1 is +ve in and the black wire on the terminal between U2 and Z2 in -ve. What is it a 12v DC motor?

This 1

https://www.ebay.com.au/itm/Alloy-M...874555?hash=item56d71831fb:g:ACMAAOSwhRZeYOMG

 

[Dihusky]

Ok, so 240v. I have to state: You should NOT be doing this, you should get an electrician to do this for you. Low voltage DC is fine, this is 240v AC mains which is a whole different story.

I am unable to give further advice mate, sorry.