Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Metal Detectors
Whites
Whites SPP Adding Conductivity switch
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Guest" data-source="post: 92819"><p>basically, the detector is running in one of those modes right now.. </p><p></p><p>If you were to buy a 3 position 3 pol toggle from jaycar.. </p><p></p><p>Ok, centre pin on the board is your common (mode its running in right now) because pins 1 and 3 aren't shorting with 2..</p><p></p><p>So, you wire pin 2 (centre) to the middle pol on the toggle, pins 1 and 3, to 1 and 3 on the board/toggle..</p><p>When you switch to position 1 or 3.. you're creating a short between 2 of the 3 pins, HI, med, Low .. </p><p></p><p>Its probably that simple, but I'm NOT! saying go ahead and try it.. If you do, its at your own risk.. (sorry just covering my arse lol)</p><p>I don't see it doing any damage, but you never know right?</p><p></p><p>Anyway that's the theory.. maybe some of the other technically minded people on the forum can chip in..</p></blockquote><p></p>
[QUOTE="Guest, post: 92819"] basically, the detector is running in one of those modes right now.. If you were to buy a 3 position 3 pol toggle from jaycar.. Ok, centre pin on the board is your common (mode its running in right now) because pins 1 and 3 aren't shorting with 2.. So, you wire pin 2 (centre) to the middle pol on the toggle, pins 1 and 3, to 1 and 3 on the board/toggle.. When you switch to position 1 or 3.. you're creating a short between 2 of the 3 pins, HI, med, Low .. Its probably that simple, but I'm NOT! saying go ahead and try it.. If you do, its at your own risk.. (sorry just covering my arse lol) I don't see it doing any damage, but you never know right? Anyway that's the theory.. maybe some of the other technically minded people on the forum can chip in.. [/QUOTE]
Verification
Post reply
Metal Detectors
Whites
Whites SPP Adding Conductivity switch
Top