Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Treasure Hunting
Treasure, Coin and Relic
Old Church site.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Nugget" data-source="post: 11408" data-attributes="member: 3"><p>Keep at it mate, there could be some nice treasure awaiting under all that trash.</p><p></p><p>One method you can try in extremely trashy areas: - </p><ul> <li data-xf-list-type="ul">Mark or designate an area to detect[/*]</li> <li data-xf-list-type="ul">Run your detector on low sensitivity OR hover the coil above the ground at approximately 70-80% of it's maximum depth penetration[/*]</li> <li data-xf-list-type="ul">Dig all targets[/*]</li> <li data-xf-list-type="ul">Then either increase the sensitivity a little OR lower the coil to around 50-60% of it's maximum depth penetration and detect over the ground again[/*]</li> <li data-xf-list-type="ul">Dig all targets[/*]</li> <li data-xf-list-type="ul">Repeat until you've reach maximum depth penetration and dug all targets[/*]</li> </ul><p></p><p>Essentially you'll be removing targets in layers.</p><p></p><p>Cheers,</p><p>Nugget</p></blockquote><p></p>
[QUOTE="Nugget, post: 11408, member: 3"] Keep at it mate, there could be some nice treasure awaiting under all that trash. One method you can try in extremely trashy areas: - [list=*] [*]Mark or designate an area to detect[/*] [*]Run your detector on low sensitivity OR hover the coil above the ground at approximately 70-80% of it's maximum depth penetration[/*] [*]Dig all targets[/*] [*]Then either increase the sensitivity a little OR lower the coil to around 50-60% of it's maximum depth penetration and detect over the ground again[/*] [*]Dig all targets[/*] [*]Repeat until you've reach maximum depth penetration and dug all targets[/*] [/list] Essentially you'll be removing targets in layers. Cheers, Nugget [/QUOTE]
Verification
Post reply
Treasure Hunting
Treasure, Coin and Relic
Old Church site.
Top