Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Gold Prospecting
Do It Yourself (DIY) Projects
Spray Bars for Highbankers
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Reeks" data-source="post: 50715" data-attributes="member: 1557"><p>I used an angle grinder with metal cutting disk in my bar. It is 1 1/4 inch pipe.</p><p>Cut the slots on an angle toward the inside of the box, no use in spraying the side of your hopper.</p><p></p><p>Your mate would be right if you had a very weak pump or very wide cuts.</p><p>If you do cuts every 20mm it will be sweet.</p><p>Good luck.</p><p>Reeko</p></blockquote><p></p>
[QUOTE="Reeks, post: 50715, member: 1557"] I used an angle grinder with metal cutting disk in my bar. It is 1 1/4 inch pipe. Cut the slots on an angle toward the inside of the box, no use in spraying the side of your hopper. Your mate would be right if you had a very weak pump or very wide cuts. If you do cuts every 20mm it will be sweet. Good luck. Reeko [/QUOTE]
Verification
Post reply
Gold Prospecting
Do It Yourself (DIY) Projects
Spray Bars for Highbankers
Top