Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Gold Prospecting
Do It Yourself (DIY) Projects
Shaking table Mk 3 -
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Moneybox" data-source="post: 677719" data-attributes="member: 3960"><p>Yes great cuts but be very careful cutting round pieces. I used my big Makita mitre saw for aluminium a lot but it never had a clamp for the material. I gave up after a few pieces left the saw, bounced off the shipping container and the roof before ending somewhere never to be seen again. The plastic safety shield has to be replaced now since it shattered on one of those occasions so I'd better deal with that sooner rather than later.</p><p></p><p>We used to have a Trennjaeger high speed steel saw of about 600mm without lubricant for cutting anything like 8" universal beams. I think they were banned in the end for safety reasons.</p></blockquote><p></p>
[QUOTE="Moneybox, post: 677719, member: 3960"] Yes great cuts but be very careful cutting round pieces. I used my big Makita mitre saw for aluminium a lot but it never had a clamp for the material. I gave up after a few pieces left the saw, bounced off the shipping container and the roof before ending somewhere never to be seen again. The plastic safety shield has to be replaced now since it shattered on one of those occasions so I'd better deal with that sooner rather than later. We used to have a Trennjaeger high speed steel saw of about 600mm without lubricant for cutting anything like 8" universal beams. I think they were banned in the end for safety reasons. [/QUOTE]
Verification
Post reply
Gold Prospecting
Do It Yourself (DIY) Projects
Shaking table Mk 3 -
Top