Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Metal Detectors
Detector Accessories
SDC2300 aftermarket coil information and questions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="mbasko" data-source="post: 479609" data-attributes="member: 4485"><p>You may possibly be able to have enough slack in the coil lead to allow the shaft to retract & coil lead to bunch down near the coil & carefully fold up to a degree - would need to check out. Should be ok? </p><p>I can loosen the cable on the GPX to shorten the lower shaft right up to put it in a bag without removing the coil/coil lead.</p><p>If not I'd say you'd have to remove the plate & undo the coil lead to allow the shaft to be retracted & fold up to fit.</p></blockquote><p></p>
[QUOTE="mbasko, post: 479609, member: 4485"] You may possibly be able to have enough slack in the coil lead to allow the shaft to retract & coil lead to bunch down near the coil & carefully fold up to a degree - would need to check out. Should be ok? I can loosen the cable on the GPX to shorten the lower shaft right up to put it in a bag without removing the coil/coil lead. If not I'd say you'd have to remove the plate & undo the coil lead to allow the shaft to be retracted & fold up to fit. [/QUOTE]
Verification
Post reply
Metal Detectors
Detector Accessories
SDC2300 aftermarket coil information and questions
Top