Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Gold Prospecting
Do It Yourself (DIY) Projects
red back and new dolly
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="davsgold" data-source="post: 674771" data-attributes="member: 6570"><p>I used Hebel Block 600x200x200 from Bunnings at the time and just cut with wood saw and drill and hole saw etc, the Hebel Block cost a whole $13 at the time and yo get 3 or 4 furnaces out of the one block as they do crack up eventually </p><p></p><p>For the dolly pot setup I used a jack hammer chisel in the hammer drill with a piece of pipe about 25mm long welded to a flat steel block 40x40x16 and then drive the chisel inside the pipe, it stopped anything snapping of along the shaft of hammer tool like what is happening to you</p><p></p><p></p><p>this whole set is like $16.98 from Bunnings just to give you an idea</p><p>[ATTACH=full]11843[/ATTACH]</p><p></p><p>and just used this one with the chisel end jammed into the pipe welded to the flat steel block</p><p>[ATTACH=full]11844[/ATTACH]</p><p></p><p>cheers dave</p></blockquote><p></p>
[QUOTE="davsgold, post: 674771, member: 6570"] I used Hebel Block 600x200x200 from Bunnings at the time and just cut with wood saw and drill and hole saw etc, the Hebel Block cost a whole $13 at the time and yo get 3 or 4 furnaces out of the one block as they do crack up eventually For the dolly pot setup I used a jack hammer chisel in the hammer drill with a piece of pipe about 25mm long welded to a flat steel block 40x40x16 and then drive the chisel inside the pipe, it stopped anything snapping of along the shaft of hammer tool like what is happening to you this whole set is like $16.98 from Bunnings just to give you an idea [ATTACH type="full"]11843[/ATTACH] and just used this one with the chisel end jammed into the pipe welded to the flat steel block [ATTACH type="full"]11844[/ATTACH] cheers dave [/QUOTE]
Verification
Post reply
Gold Prospecting
Do It Yourself (DIY) Projects
red back and new dolly
Top