Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Gold Prospecting
Prospecting Equipment
Pump this, Sluice that...
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Terrraaustralis2014" data-source="post: 164368" data-attributes="member: 5011"><p><a href="http://youtu.be/WVeIHjneC2E" target="_blank">http://youtu.be/WVeIHjneC2E</a></p><p></p><p><a href="http://youtu.be/fVsMuJonh3k" target="_blank">http://youtu.be/fVsMuJonh3k</a></p><p></p><p>Changed the spray bars from 3/4 inch to 1 full inch.</p><p></p><p>Easier on the engine, runs on lower rpm now</p><p></p><p>Cut a 12 slots instead of the previous 8 on either side of the 3/4 riser.</p><p></p><p>....runs nicely.</p><p></p><p>What should I do about that wave ( rooster tail ) I've got there. Just need some info before I go off 'half-cocked'</p><p></p><p>Also, the material in the mesh is after about 20 minutes of running. It was two twenty litre buckets and I'm not sure if I've got it working correctly. It seems overloaded for how little i be run. Those big rocks just clog up the first section of the slopes mesh and I'm sure that it affects the performance of the expanded section. 8.( </p><p></p><p>Cheers</p><p></p><p>Chris.</p></blockquote><p></p>
[QUOTE="Terrraaustralis2014, post: 164368, member: 5011"] [url]http://youtu.be/WVeIHjneC2E[/url] [url]http://youtu.be/fVsMuJonh3k[/url] Changed the spray bars from 3/4 inch to 1 full inch. Easier on the engine, runs on lower rpm now Cut a 12 slots instead of the previous 8 on either side of the 3/4 riser. ....runs nicely. What should I do about that wave ( rooster tail ) I've got there. Just need some info before I go off 'half-cocked' Also, the material in the mesh is after about 20 minutes of running. It was two twenty litre buckets and I'm not sure if I've got it working correctly. It seems overloaded for how little i be run. Those big rocks just clog up the first section of the slopes mesh and I'm sure that it affects the performance of the expanded section. 8.( Cheers Chris. [/QUOTE]
Verification
Post reply
Gold Prospecting
Prospecting Equipment
Pump this, Sluice that...
Top