Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Metal Detectors
Other Brands
Gold Bug issue or not issue.??
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Adrian ss" data-source="post: 548557" data-attributes="member: 14143"><p>Ground Phase can drift around if there is EMI about and while scanning depending on the variability of the ground</p><p>The most accurate Ground Phase reading is when you are ground balancing in all metal mode using the GG function. The reading is unlikely to be a rock steady reading if the ground is highly mineralised but when GB ing the ground phase should settle close to the ground balance reading after you release the GG button. There may be some small differences between the two readings. If there is a large diff then Ground balance has not been achieved.</p><p></p><p>Holding the detector motionless with the coil well above the ground and clear of all metal and if there is no EMI the Ground phase should be steady.</p></blockquote><p></p>
[QUOTE="Adrian ss, post: 548557, member: 14143"] Ground Phase can drift around if there is EMI about and while scanning depending on the variability of the ground The most accurate Ground Phase reading is when you are ground balancing in all metal mode using the GG function. The reading is unlikely to be a rock steady reading if the ground is highly mineralised but when GB ing the ground phase should settle close to the ground balance reading after you release the GG button. There may be some small differences between the two readings. If there is a large diff then Ground balance has not been achieved. Holding the detector motionless with the coil well above the ground and clear of all metal and if there is no EMI the Ground phase should be steady. [/QUOTE]
Verification
Post reply
Metal Detectors
Other Brands
Gold Bug issue or not issue.??
Top