Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Metal Detectors
Minelab
Equinox Software Updates v2.0 v3.0
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Pieces-Of-Eight" data-source="post: 514933" data-attributes="member: 15910"><p>Thanks Rock Dev :Y: , I set up using the following (which is as smart as I am at the moment)</p><p>Factory default , then beach 1, check for interference, auto ground balance, F2 bias 2 (haven't played further with this yet and hadn't looked at this setting before), sensitivity 17 (though I do click up and down 1 or 2 if i'm unsure about a weak target.</p><p></p><p> I did also try in the all metal mode to see if I would hit multiple target types (this has worked previously for me getting the double tone e.g. 6 and 13/14). on the whole I was just getting straight 13s 14s </p><p>When switching to pinpoint the signal did got a lot more scratchy which made me suspicious, </p><p>Its highly possible the nox was doing what it was supposed to and I would have ended up digging a bunch more tops.</p><p></p><p>Next time i'll run in FE mode, and when I suspect a top i'll switch to F2 and see how its different.</p><p>Steve</p></blockquote><p></p>
[QUOTE="Pieces-Of-Eight, post: 514933, member: 15910"] Thanks Rock Dev :Y: , I set up using the following (which is as smart as I am at the moment) Factory default , then beach 1, check for interference, auto ground balance, F2 bias 2 (haven't played further with this yet and hadn't looked at this setting before), sensitivity 17 (though I do click up and down 1 or 2 if i'm unsure about a weak target. I did also try in the all metal mode to see if I would hit multiple target types (this has worked previously for me getting the double tone e.g. 6 and 13/14). on the whole I was just getting straight 13s 14s When switching to pinpoint the signal did got a lot more scratchy which made me suspicious, Its highly possible the nox was doing what it was supposed to and I would have ended up digging a bunch more tops. Next time i'll run in FE mode, and when I suspect a top i'll switch to F2 and see how its different. Steve [/QUOTE]
Verification
Post reply
Metal Detectors
Minelab
Equinox Software Updates v2.0 v3.0
Top