Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Gold Prospecting
Do It Yourself (DIY) Projects
DIY Plug Digga Spade plans with stick on template and instructions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="hyperscott" data-source="post: 299479" data-attributes="member: 7623"><p>Hi greenhornet_au</p><p></p><p>Yes used your template, slipped a little though.</p><p></p><p>But came up nice. shovel worked well, used it yesterday. Very slight cutting edge on the shovel yes, will likely try sharpening it at some stage if i find it needs it.</p><p></p><p>That's a great tip around the masonry bits, ill give that go at some stage.</p><p></p><p>Didn't take very long at all maybe a half hour due to drilling holes. </p><p></p><p>I ended up just cutting with the angle grinder and then putting a grinding blade in to ensure the slots where straight and put the edge on them. Worked ok.</p><p>likely will do the same thing next time just measure out the slots and then use the cutting blade.</p><p></p><p>was a nice and easy process and enjoyed it yes.</p><p></p><p>Thanks</p></blockquote><p></p>
[QUOTE="hyperscott, post: 299479, member: 7623"] Hi greenhornet_au Yes used your template, slipped a little though. But came up nice. shovel worked well, used it yesterday. Very slight cutting edge on the shovel yes, will likely try sharpening it at some stage if i find it needs it. That's a great tip around the masonry bits, ill give that go at some stage. Didn't take very long at all maybe a half hour due to drilling holes. I ended up just cutting with the angle grinder and then putting a grinding blade in to ensure the slots where straight and put the edge on them. Worked ok. likely will do the same thing next time just measure out the slots and then use the cutting blade. was a nice and easy process and enjoyed it yes. Thanks [/QUOTE]
Verification
Post reply
Gold Prospecting
Do It Yourself (DIY) Projects
DIY Plug Digga Spade plans with stick on template and instructions
Top