Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Outdoor & Recreation
Camping
DEEP CYCLE BATTERIES and BUSH POWER
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Ridge Runner" data-source="post: 633412" data-attributes="member: 3775"><p>With my Lithium it has a voltage range of 16 to 60v+ so when I hook panels in series the Higher the Voltage, The higher the Voltage means more watts, </p><p></p><p>This all works out fine if I keep the Amps under 10A, If I put 2 in series I can get around 250 to 300w, If I put 3 in series I can get IE 375 to around 480w with the votage around 54 to 60v, </p><p></p><p>If One panel gets shaded then I am getting a reduced Voltage which means my Watts are Lower but I am still getting over 18V+, where I can get 18v from One panel and IE 11v from another panel fo my Voltage gets reduced to around 29v instead of 36 to 40v+/-, OR 18v + 18v + 11v = 47v but I still get the Watts those voltages produced,</p><p></p><p>If I over Volt and put 4 panels in series the PowerOak/Bluetti EB180 puts up and error code and won't charge until I remove the 4th Panel and reset the EB180, The Internal Input is 600w but it is Capped at 500w and the most wattage it will allow in is 505w / 64v +/-, I can over Watt the sysem to make sure I get full power on cloudy days BUT I can't Over Volt the System or it puts up the Error Code and shuts down.</p></blockquote><p></p>
[QUOTE="Ridge Runner, post: 633412, member: 3775"] With my Lithium it has a voltage range of 16 to 60v+ so when I hook panels in series the Higher the Voltage, The higher the Voltage means more watts, This all works out fine if I keep the Amps under 10A, If I put 2 in series I can get around 250 to 300w, If I put 3 in series I can get IE 375 to around 480w with the votage around 54 to 60v, If One panel gets shaded then I am getting a reduced Voltage which means my Watts are Lower but I am still getting over 18V+, where I can get 18v from One panel and IE 11v from another panel fo my Voltage gets reduced to around 29v instead of 36 to 40v+/-, OR 18v + 18v + 11v = 47v but I still get the Watts those voltages produced, If I over Volt and put 4 panels in series the PowerOak/Bluetti EB180 puts up and error code and won't charge until I remove the 4th Panel and reset the EB180, The Internal Input is 600w but it is Capped at 500w and the most wattage it will allow in is 505w / 64v +/-, I can over Watt the sysem to make sure I get full power on cloudy days BUT I can't Over Volt the System or it puts up the Error Code and shuts down. [/QUOTE]
Verification
Post reply
Outdoor & Recreation
Camping
DEEP CYCLE BATTERIES and BUSH POWER
Top