Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Gold Prospecting
Do It Yourself (DIY) Projects
Build your own pick handle
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Lesgold" data-source="post: 597996" data-attributes="member: 9840"><p>Hi Manpa,</p><p></p><p>Give it a go. It is a very simple process. If you can turn a cylinder on the lathe, the offset turning to make the oval will be a breeze. The trick with the offset turning is to only remove a small amount of material. For this particular handle only 5mm was shaved from each side. It would be very easy to take too much off. Good luck.</p><p></p><p>Cheers</p><p></p><p>Les</p></blockquote><p></p>
[QUOTE="Lesgold, post: 597996, member: 9840"] Hi Manpa, Give it a go. It is a very simple process. If you can turn a cylinder on the lathe, the offset turning to make the oval will be a breeze. The trick with the offset turning is to only remove a small amount of material. For this particular handle only 5mm was shaved from each side. It would be very easy to take too much off. Good luck. Cheers Les [/QUOTE]
Verification
Post reply
Gold Prospecting
Do It Yourself (DIY) Projects
Build your own pick handle
Top