Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
General
General Chat
A question for the Tradies.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="wiley coyote" data-source="post: 606646" data-attributes="member: 7587"><p>I had to pull out a sheet of corrugated iron from the middle of the roof, which was a very simple job. Putting it back on was a totally different story! I slid it under the sheet above it, but it jammed on the beam under that sheet. The sheet I was trying to slide in had a slight bow in the centre and wouldn't pass over the beam. In the end I had to loosen two more sheets to manoeuvre the first sheet over the beam. They all had roofing nails in them. That was fun getting them out! What started out as a simple job pulling the sheet out turned into a one hour plus ordeal! Does anyone know any tricks to slide the sheet back in without having to loosen the sheets around it? Cheers wiley</p></blockquote><p></p>
[QUOTE="wiley coyote, post: 606646, member: 7587"] I had to pull out a sheet of corrugated iron from the middle of the roof, which was a very simple job. Putting it back on was a totally different story! I slid it under the sheet above it, but it jammed on the beam under that sheet. The sheet I was trying to slide in had a slight bow in the centre and wouldn't pass over the beam. In the end I had to loosen two more sheets to manoeuvre the first sheet over the beam. They all had roofing nails in them. That was fun getting them out! What started out as a simple job pulling the sheet out turned into a one hour plus ordeal! Does anyone know any tricks to slide the sheet back in without having to loosen the sheets around it? Cheers wiley [/QUOTE]
Verification
Post reply
General
General Chat
A question for the Tradies.
Top