Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Gold Prospecting
Do It Yourself (DIY) Projects
3D Model - Black Sand Magnet Recycle Old Hard Drive Magnets
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Boulders" data-source="post: 299460" data-attributes="member: 9024"><p>That actually didn't take long at all because it was a single layer spiral print. So it just kept going round and round and built up the layer. </p><p></p><p>I think it was a couple of hours or so, which is pretty quick in 3d printing terms... Lol </p><p></p><p>The slicing software is the key to getting a good result. I use Simplify 3D which cost me $150 when our dollar was pretty much on par with the US but the results are noticeable compared to alot of the free software.</p></blockquote><p></p>
[QUOTE="Boulders, post: 299460, member: 9024"] That actually didn't take long at all because it was a single layer spiral print. So it just kept going round and round and built up the layer. I think it was a couple of hours or so, which is pretty quick in 3d printing terms... Lol The slicing software is the key to getting a good result. I use Simplify 3D which cost me $150 when our dollar was pretty much on par with the US but the results are noticeable compared to alot of the free software. [/QUOTE]
Verification
Post reply
Gold Prospecting
Do It Yourself (DIY) Projects
3D Model - Black Sand Magnet Recycle Old Hard Drive Magnets
Top