Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Charts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Metal Detectors
Detector Accessories
19" for the 7000
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Prospecting Australia:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="PhaseTech" data-source="post: 542294" data-attributes="member: 3149"><p>The Patch Locate setting soaks up the ground a little better, similar to what faster motion settings on the 5000 do, which is important if you are patch hunting and trying to swing a little faster. But even swinging slower or at normal speed, having Patch Locate on may allow you to use Normal ground type where you'd previously just switched into Difficult. </p><p></p><p>As an example, here's two setting combos that I can run in medium mineralised soils:</p><p></p><p>1. Normal, General, Patch Locate, Audio Smoothing Low, Sens 6-9</p><p></p><p>2. Difficult, HY, G Smoothing Off, Audio Smoothing Low or High, Sens 12-16</p><p></p><p>The end result of how the detector runs both to ground and EMI noise is about the same, but combo 1 would have the edge on depth to bigger gold, and Combo 2 would have the edge on very small stuff. </p><p></p><p>Cheers, Nenad</p></blockquote><p></p>
[QUOTE="PhaseTech, post: 542294, member: 3149"] The Patch Locate setting soaks up the ground a little better, similar to what faster motion settings on the 5000 do, which is important if you are patch hunting and trying to swing a little faster. But even swinging slower or at normal speed, having Patch Locate on may allow you to use Normal ground type where you'd previously just switched into Difficult. As an example, here's two setting combos that I can run in medium mineralised soils: 1. Normal, General, Patch Locate, Audio Smoothing Low, Sens 6-9 2. Difficult, HY, G Smoothing Off, Audio Smoothing Low or High, Sens 12-16 The end result of how the detector runs both to ground and EMI noise is about the same, but combo 1 would have the edge on depth to bigger gold, and Combo 2 would have the edge on very small stuff. Cheers, Nenad [/QUOTE]
Verification
Post reply
Metal Detectors
Detector Accessories
19" for the 7000
Top