Search results

To avoid the problems with the 6000 it's easy buy an garrett axium as good as the 6000 build quality is far better and 2k cheaper. Just my opinion. PP

That's why I bought an axium not a 6000

Hi all been a while but I thought I would tell you my little experiance with regaurds to my garrett Axium , I bought an Axium second hand from a forum member love it by the way, anyway was out with it just before xmas and noticed that the control panal was lose had a look and the joint between...

Well from what I have hearing you better add another 1k to your 6000 over priced think they are only looking after the shareholders and stuff the punters .PP

They look good Dave , the vice has two dowl insertes in the centre tube the blade or tang can be inserted tighten the scew and its held firmly while you work on the knife i will put a couple of photos up later .PP

today I made this what is it I hear you say , well nothing to do with gold it's a knife makers vice ,will be putting them up for sail soon just thought I would show you all something different. PP

today I made a 240v Rock crusher really happy with the end product .PP

Pm sent I think LOL

Hi just wondering if your axium is still available. Pete

You can buy a z link receiver that will allow you to tune in any Bluetooth system to the axium will cost you about 160 bucks hope this helps you out

Oz Wash sluices Eaglehawk Vic is a Garrett dealer and has axium in stock Phil is a straight guy and easy to deal with. PP

Hi all been a while I am in eaglehawk victoria and I make 240v rock crushes there is a fair bit of work in them ,the one I make do not use chain it has a 3 bar blade setup and the rock is reduced to powder I don't like angle grinders hanging of the back of thing mine has a 240v motor and rotates...

Yes Phil has only had the shop for a while and is slowly upgrading everything but believe me he has a full complement of detectors and I know for a fact he has axioms in stock he has sold a few already and I will be buying one in a couple of months time when I have the cash give him a call he is...

Call the prospectors depot eaglehawk victoria he is a Garrett dealer and has axium in stock

Well got it on to utube this is the link if you watch till the end shows you the fines .PP

L

Hi Moneybox No mess i cut slots into the drum so no mesh is needed. and THanks dave .PP

Hi Northeast it is driven by attaching a power drill too the drive shaft and it is made at an angle to allow the fines to drop out of the bottom where there are slots cut in you put a container under it to catch them, so the only time you have to empty it is when you have finished to clean it...

well today i made a prototype rock crusher works really well takes the rock down to powder so really happy with it .PP

Well send me a PM and tell me which handle you want pick handle or detector handle .PP