Search results

There is so much more to learn about the 5k, eg.. From memory on a test I did, (in particular settings) a 0.3 gram bit at 10 inches I can make it sound like a 1 grammer at 3 inches just by switching from fine gold to sensitive extra with the 17x13, if I drew a responce/depth curve the responce...

Does anyone here wanna have a crack at the obvious receculating gold responce I have when I put the target in my scoop over the 17x13 evo..

It's 2 sides of coin but not, nature eventually destroys what it creates, and even if not its still going to be a slower decomposition of anything else. The only way we can construct is by the deconstruction to mine for something else. A Sci fi quote from the movie aliens covenant, "One must...

It isn't until you go buy a new pick that you realise just how worn out your old one is 🤣 Bought a big brother this time, ground killer, time to strip 😎

Walking around surfaced areas, the 'edges' are what I only show interest in. The main area of the surfaced workings is allways red iron clay, I think that's actually the bedrock that if I recompose and un-oxidies it's as deep as the gold from the old reef gravels the layed out to sink. Iron...

What is the black material that's on each side the contact zone of a fault that holds the gold?

Does the 6k and 7k have motion speed responce settings? And do either of them have target I'd volume settings?

What did the diggers drink (in the early vico gold rush) ?

After you have moped up even with the little gold hawks, what then

Is there anyone here who can help me with some OLD math.. If 2 old timers paid for a claim, spent weeks sinking an elavial shaft to 20ft, belled out and only got 2 ounces. Without taking in to account of time down and spent on infrastructure to keep them alive, water rates from the race, puddle...

Goldierocks, from what I'm experiencing from this 1 gully, @ approx 2m down there is a layer of gravels approx 0.5m thick, there is SOME gold in it but from deeper digging the ground is turning white/orange clay. What's deeper?

Started with a new company on a project in the smythesdale area. Most of the conglomerate cap has allready been taken out but there are bits left around the site..

If I put 2 inch reducers on the inlet and outlet of a 3 inch pump, will I save fuel and require less revs than a 2 inch pump?

Finally arrived from the UK, 1.. 22mm o/d, 20mm i/d x 1000mm 2.. 19.7mm o/d, 18mm i/d x 1000mm This should be fun 🤣

Let's see what's down there.. Coffin length = 1.6m Width = 0.6m Session 01 duration = 2.5 hrs Depth = 0.5m ...

Same bits as post #184 from back outback thread. Ruff rubbed.. Photo in water.. Make me an offer? Scott :cool:

For the people that view this forum on a pc, is there a view count beside topics?

https://youtu.be/c7iv1fef6qo

First sunset..