Recent content by Rustyone

Thanks Condor22. Appreciated. I'll leave you guys alone now...lol. Rusty

Hi AuMan. yep, the mono was very bump sensitive. Must of been one of the bad batches of coils a few years ago. That was an easy fix. I had it apart checked the solder joint and re-secured everything and used conductive paste, sealed the shield and components etc. It was still sensitive to bumps...

Hi all, Thanks for the feedback. A bit of trial and error in my future, I'm thinking. While I've got you, I like the round 11" as I work in a lot of heavily timbered and scrub areas so the edge of the 11" round can get into those nooks and crannies around the tree stumps..How are the elliptical...

Hi all, Have a 4500 and my 11 mono finally crashed ( worst coil I'd ever had...so noisy due to crap connections). I switched to the DD and all was good until I stopped for a break. When I turned it back on there was a huge squeal about 2 seconds later, that continued. I tried to auto tuned but...

Do your research before buying a Pro find 35. Very expensive and has issues, My comment in relation to the above YouTube below: Youre kidding me. I thought that it was me! Same issues. There is nothing in the instruction about ground balancing (I just checked and the instructions are the...

I Signed Yesterday and submitted my own questions to the Department. When and if I get a reply I'm going to my local member..."Battle!". :Y: Russ

This is probably a bit late but this is for future reference. DONT USE NITRIC ACID on gold coated items. It will attack the substrate and lift the gold off the item. ie: we use nitric to lift the gold coatings from computer CPU lids and other items. The best way is to simmer the item in full...

I think that we need to clarify one thing. Dredging IS NOT ILLEGAL in NSW per say. You just need a permit from the Dept of Primary Industries. You will need a Part 7 Fisheries Management Act permit for activities involving dredging and reclamation work. I applied about 5 years ago to do a spot...